Datalogic Gryphon I GBT4400 2D User Manual

Connecting the Base Station
12 Gryphon™ I GBT4400 2D
Using the BC40xx™ Radio Base
Radio Base LEDs
LEDs on the Gryphon Base provide information about the
Bases well as battery charging status, as shown in Figure 7.
Figure 7. Gryphon Base LEDs
Table 1. Radio Base LEDs
The button can be used to force device connection via the
Datalogic Aladdin Software tool, to force a BT disconnect,
and for paging the scanner when it is activated. Refer to the
Gryphon 2D Product Reference Guide (PRG) for a more de-
tailed explanation.
LED STATUS
Power on /
Data
Yellow On = Base is powered
Yellow Blinking = Base receives data
and
commands from the Host or the
Reader.
Charging Red On = the Battery is charging.
Charge com-
pleted
Green On = the Battery is completely
charged.
Charging +
Charge com-
pleted
Red and Green Blinking together = the
Reader is not correctly placed onto the
Base.
YELLOW LED
RED LED —
GREEN LED
BUTTON

Datalogic Gryphon I GBT4400 2D Specifications

General

Scanner Type	2D Imager
Connectivity	Bluetooth
IP Rating	IP52
Print Contrast Ratio (Minimum)	25%
Interface	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-20 to 70 °C / -4 to 158 °F
Drop Resistance	1.8 m (6 ft) to concrete
Weight	245 g / 8.64 oz
Dimensions	18.1 x 7.1 x 10.0 cm / 7.1 x 2.8 x 3.9 in
Light Source	Red LED
Image Sensor	CMOS
Decode Capability	1D / 2D / Postal / Stacked codes
Scanning Technology	Imaging
Resolution	752 x 480 pixels
Skew Angle	+/- 65°
Humidity	5 to 95% non-condensing
Drop Specification	1.8 m (6 ft) to concrete
Power Supply	5 VDC +/- 5%
Beeper	Yes
Indicators	LEDs, Beeper
Supported Barcodes	All standard 1D and 2D barcodes