1D Symbologies Enter/Exit Programming Mode
Product Reference Guide 173
I 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for I 2 of 5 Length Control on
page 171
. Length 2 is the maximum label length if in Variable Length on page
176
Mode, or the second fixed le
ngth if in
Fixed Length on page 176 Mode. The
length includes the bar code’s check
and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore
this length (only one fixed length). See
"Set Length 2" on
page 303 for more
detailed programming instructions.
Select I 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CI2L2
~
To Next Page
Loading...
