Enter/Exit Programming Mode Codabar
182 Gryphon™ I GD/GBT/GM4500
Codabar Length Control
This feature specifies either variable length decoding or fixed length decoding
for the Codabar symbology.
Variable Length:
For variable length decoding, a minimum and maximum length
may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
DEFAULT
Codabar Length Control = Variable Length
Codabar Length Control = Fixed Length
Codabar Set Length 1
This feature specifies one of the bar code lengths for Codabar Length Control
on page 182
. Length 1 is the minimum label length if in Variable Length on
page 182
Mode, or the first fixed length if in Fixed Length on page 182 Mode.
Length includes the bar code’s start, stop, ch
eck and data characters. The
length must include at least one data character.
The length can be set from 3 to 50 characters. See
"Set Length 1" on
page 302
for more detailed programming in
structions.
1
Select Codabar Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
03 = Length 1 is 3 Characters
To Next Page
Loading...
