General Features
22 QuickScan
TM
QD2100
Good Read: When to Indicate
This feature specifies when the reader will provide indication (beep and/or flash its green
LED) upon successfully reading a bar code. Choices are:
• Good Read = Indicate after decode
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then activ
NOTE
This option, which uses CTS, is only valid for RS-
232
interfaces.
e
ENTER/EXIT PROGRAMMING MODE
Indicate Good Read = After Decode
Indicate Good Read = After Transmit
Indicate Good Read = After CTS Goes Inactive, Then
Active
To Next Page
Loading...
