Extended System-Level Command Functions
88 Class Series Programmer’s Manual
(WE) WiFi Setup – This command configures the printer for a WiFi connection.
Value Parameter Interpretation Default Value
A y
Is the WiFi SSID, where:
y = Up to 31 characters, no spaces
MACR
C x
Is the WiFi Channel number (adhoc only, country
dependant), where:
x = 1 to 14
1
F x
Is WiFi Enable DHCP Fixed Interval
Transmission, where x:
1 = Fixed
0 = Exponential
0
I xxx.xxx.xxx.xxx
Is the WiFi IP Address*, where:
x = 0 to 9
192.168.010.001
L x
Is the WiFi DHCP Acquire Time Limit, where:
x = 0 to 255 seconds
150
M x
Is the WiFi maximum transmission rate, where x:
0 = 1 Mbps
1 = 2 Mbps
2 = 5.5 Mbps
3 = 11 Mbps
2
N y
Is the WiFi client name, where:
y = Up to 31 characters, no spaces
N/A
P x
Is the WiFi WEP Access Point Density, where x:
0 = Low
1= Medium
2 = High
0
R y
Is the WiFi Region, where:
y = two-character mnemonic; see Appendix U.
US
T x
Is the WiFi Mode, where x:
0 = Adhoc
1 = Infrastructure
2 = Unique (SSID = MAC address; and, WiFi
type = Adhoc)
2
V x
Is the WiFi DHCP Retransmit Interval, where:
x = 1 to 64 seconds
15
X a
Is WiFi MAC Cloning, where a:
0 = Disable
1 = Enable
0
* Each octet must be zero-filled to be properly interpreted (e.g., an IP Address of 10.12.0.243 must be sent to the
printer as 010.012.000.243).
Table 5-13 WiFi Setup
Example 1:
<STX>KcNTDN;NTwN;WEI010.012.000.248;WEAEngWAN1;NTI010.012.000.245;NTS
255.255.000.000;NTG010.012.254.254<CR>
To Next Page
Loading...
