Label Formatting Command Functions
Class Series Programmer’s Manual 117
P Set Print Speed
This command sets a print speed for a label or batch of labels.
Syntax:
Pa
Where:
a
- Is a single character representing a speed; see Appendix L for
valid ranges.
Sample:
<STX>L
PC
141100001000100LABEL1<CR>
E
<STX>L
141100001000100LABEL2<CR>
E
The sample prints two labels, the first at a speed of 2 inches per second (51 mm per second) and the
second at the printer default.
p Set Backfeed Speed
This command, typically used in conjunction with the Cut or Peel and Present operations, controls the
rate at which the labels will reverse to align to the next start of print position. The setting remains in
effect until another backfeed speed command is received or until the printer is reset.
Syntax:
pa
Where:
a
- Is a single alpha character representing a speed; see Appendix
L for valid ranges.
Sample:
<STX>L
pF
The sample sets the printer to a backup speed of 3.5 IPS.
To Next Page
Loading...
