Label Formatting Command Functions
114 Class Series Programmer’s Manual
f Set Present Speed
(Non-Display Models only)
This command controls the rate at which the present distance is positioned, allowing the media
movement to be slowed during ‘presentation’ (the distance traveled after printing is completed to the
label stop position). This command is used only within the context of a label format. The speed
assigned is retained until another label format is received or until power is removed; if a subsequent
format does not contain a present speed command then the present speed reverts to the feed speed.
Syntax:
fa
Where:
a
- Is a single alpha character representing a speed, limited by the
feed speed range; see Appendix L. The default is the feed speed.
Sample:
<STX>LD11H30PGSG
fA
191100200830165Fixed Data Field 1
E
<STX>L
191100200830165Fixed Data Field 1
E
The sample prints two labels; the first label has present speed of 1 inch per second, while the second
reverts to the feed speed of 4 inches per second.
G Place Data in Global Register
The ‘G’ command saves the print data of a print format record in a global register (temporary
storage). This data may be retrieved and copied to another record in the same label format using the
special Label Formatting Command: <STX>S. Global registers are named in the order received,
beginning with register A, ending at register P, and incrementing with each instance of the G
command use.
Syntax:
G
Sample:
<STX>L<CR>
121100000000000Testing<CR>
G<CR>
1A2210001000000<STX>SA<CR>
E<CR>
The sample stores, retrieves and prints the data in global register A. One label is printed with
“Testing” in two locations.
To Next Page
Loading...
Need help?
General