Extended System-Level Command Functions
76 Class Series Programmer’s Manual
Write/Verify hexadecimal response example:
<R;C;01;01;0012:0001;446174616D61782077726974657320524649442062657374>[CR]
Read hexadecimal response example:
<R;C;01;01;0013:0001;446174616D61782077726974657320524649442062657374>[CR]
Write/Verify ASCII response example:
<R;C;01;01;0012:0001; Datamax writes RFID best >[CR]
Read ASCII response example:
<R;C;01;01;0013:0001; Datamax writes RFID best >[CR]
Scanner response samples:
A successfully read label example:
<S;C;03;03;0002:0001;DATA1;DATA2;DATA3>[CR]
A failed label, successfully retried:
<S;F;02;01;0002:0001;DATA1>[CR]
<S;C;02;02;0002:0001;DATA1;DATA2>[CR]
(PA) Present Adjust – This command fine-tunes the Present Distance setting in dots to
compensate for slight mechanical differences sometimes evident if multiple printers share label
formats. The
EX2 accepts this command for backward compatibility only, limited in range (28-
228). <STX>KcQQQ response shows the
Present Adjust Fine Tune (PJ) equivalent value.
(PC) Print Contrast – This command adjusts the relative print edge (gray) component of the print
quality, which allows fine-tuning for specific media/ribbon mix.
(PD) Present Distance – This command sets the label stop position past the start of print. When
the next label format is received, the printer will automatically backfeed to the start position. If
the present distance is set to zero, the printer will operate without reversing. (See Stop Location,
below).
(PE) Peel Mode – This command, when enabled, specifies that a Feed operation be prevented
when the label is presented and not removed, or if the printer is to wait for the GPIO start of print
signal.
To Next Page
Loading...
Need help?
General