Extended System-Level Command Functions
Class Series Programmer’s Manual 83
(SA) SOP Adjust – This command sets the start of print (SOP) location, relative to the top of
form. See <STX>O for command details. The
EX2 accepts this command for backward
compatibility only, limited in range (28-228). The <STX>KcQQQ response shows the Row
Adjust Fine Tune (RF) equivalent value.
(SC) Scalable Cache – This command sets the number of 1K blocks allocated for the scaleable
font engine. Available memory dependent upon model; see Appendix K. (For non-display models
see the <STX>KS command.)
(SE) SOP Emulation – This command enables the <STX>O and <STX>f print positioning
commands to allow backward compatibility with label formats designed for other printers.
(SF) Save As Filename – This command, which may be sent separately or included as the last
command in an <STX>Kc command string, saves the effective printer configuration to a file in
Flash memory with a .dcm file extension.
(SG) Sensor Gain Value – This command sets the control of the voltage to the LED emitter of
the Media Sensor.
(SH) Scalable Heap – This command sets a working “scratch pad space” in DRAM for scalable
font construction.
(Sl) Security Lock – This command provides the ability to password-protect all printer settings
made through the User Interface, as follows:
Value Security Function
Nxxxx
Where xxxx is the current password, this disables Menu protection.
Yxxxx
Where xxxx is a new password, this enables Menu protection and sets a new password.
Txxxx
Where xxxx is a new password, this enables Menu protection, disables the User
Interface Test Button functions, and sets a new password.
Table 5-9: Security Lock Command
To Next Page
Loading...
Need help?
General