A-Class 73
Prompts and Condition Messages (continued)
Displayed Message Description Action
REMOVE RIBBON
PRESS ANY KEY
The TEST Key was pressed and
held, or CLEAN HEAD NOW was
selected, but ribbon is installed.
Remove ribbon and press
any key to proceed.
SAVE CHANGES?
Database changes were made
that require confirmation.
Press YES to accept the
changes, or NO to discard
them.
;
If required, a reset will
automatically occur.
SUCCESSFUL
PRESS ANY KEY
The selected operation was
successfully completed.
Press any key to continue.
SYSTEM INITIALIZING
The power switch has been
turned ON or a reset has
occurred.
No action is required. Wait
briefly while the process
completes.
SYSTEM RESET
IN PROGRESS
A reset has occurred.
No action is required. Wait
briefly while the process
completes.
UNCALIBRATED
The Media Sensor is not
calibrated.
Perform calibration; see
Section 5.2.
WAITING FOR DATA
SOP signal has been received,
but the printer awaits label
data.
Send a format from the
host.
WAITING FOR SIGNAL The printer awaits a SOP signal.
Send the SOP signal from
the
applicator to the GPIO
port.
XXXX OF XXXX
PRINTING
A print job is in process, as
indicated by the batch total and
remaining label count.
No action is required.
To Next Page
Loading...
