To Next Page

To Previous Page

118 M-Class

8. Use the

FWD

and

REV

buttons to increment/decremnt the

flashing value. Press the

button to move to the next

field. Once all fields are correct press the

button once.

The value will automatically be saved.

You can then use the

FWD

to scroll to the ‘SUBNET MASK

and ‘GATEWAY’ menu items and set those values in the same

manner as the

‘IP ADDRESS’ was set.

JQ!BEESFTT!

+2:3/111/111/2:3!

TVCOFU!NBTL!

+111/111/111/111!

HBUFXBZ!

+111/111/111/111!



Note: When the menu item ‘IP DISCOVERY’ is set to enabled you will not be able to change the values for the “IP

ADDRESS’, ‘SUBNET MASK’, or ‘GATEWAY’ menu items. The values displayed are for reference only and

will become active once ‘IP DISCOVERY’ set to disabled.

9. Once you have the proper addresses set, press the

button

repeatily until you have exited the printer’s menu. Turn OFF the

printer and then back ON.

XFE!21;27B!13KVM3114!

SFBEZ!

Once you have entered your IP settings into the printer you can then install the port and printer driver using the Windows

‘Add a Printer Wizard’. See section, Installing the Printer Driver and Port in this document.

Datamax M-Class User Manual

Questions and Answers: