dCS Bartók DAC User Manual Software Issue 1.0x
February 2019
Bartok DAC Manual v1_0x Page 28 English version
Using the Bartók DAC with a Transport and Clock
The Rossini Clock has a third output (normally fixed at 44.1kHz), which may be used to clock another
source, such as an SACD Transport.
Figure 7 – Using the Bartók DAC and Rossini Clock with a Rossini Transport
• Connect the system as shown above.
• Use the DAC’s Input button to select the input you want to use (AES1+2 in the example).
Set the DAC’s Unit Settings > Sync Mode menu page to Word Clock 1-2 Auto mode.
The Rossini Transport will lock to the word clock and display this icon.
• If you want to listen to CD playback in native 16/44.1 format, connect one of the Transport’s SPDIF
outputs to the DAC’s matching input. Select that input and set it to Word Clock Sync also.
Now, sit back and enjoy the music.
When you have finished listening, you can either keep the DAC warm by setting it to Sleep mode
(press the Power button briefly) or switch off (hold down the Power button until SWITCHING OFF is
displayed, then release).
Analogue outputs
To Next Page
Loading...
