dCS Bartók DAC User Manual Software Issue 1.0x
February 2019
Bartok DAC Manual v1_0x Page 33 English version
Control Modes
The functions of the front panel controls depend on the current operating mode of the DAC, as shown
in the table below.
MODE
DAC /
Network
Power Menu Filter Input Mute
Menu
Close Select ◄ Menu Menu ► ---
USB2
Browser
Close Select Cursor ▲ Cursor ▼ Folder ▲
Power Button
To switch on, ensure the rear panel power switch is set to I and press the Power button (C) on the
front panel once. Note that the unit cannot be turned on from the remote control.
To set the unit to sleep mode, press the Power button once. The main display will turn off, the LED
beside the button will illuminate and the outputs will be muted, but the unit will remain close to running
temperature. Press again to return to normal operation.
To switch off, hold down the Power button for about 5 seconds until SWITCHING OFF appears on the
display, then release it.
Pressing the Power button briefly will close the menu or the browser.
Menu Button
Press the Menu button (D) to open the menu, select menu pages and change settings. See the Menu
section on page X38 for information on using the menu features.
With a USB flash drive fitted to the USB2 port, hold the Menu button down for 2 seconds to open the
file browser and select folders or tracks.
Filter Button
When receiving PCM data, the Filter button (E) selects a different anti-image filter. When receiving
DSD data, the Filter button selects a different DSD Filter instead. See the Filter menu section on page
41 for details.
When the menu or browser is open, the Filter button changes to the ◄ button, used to page
backwards through the menu or up the track list.
To Next Page
Loading...
