EasyManua.ls Logo

DEC VT1000 - Testing the LAT

Default Icon
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Testing 29
2.3 Testing the LAT
The LATCP utility allows you to control and obtain information from the
LAT port driver (LTDRIVER). Using the LATCP, you can do the following:
Start and stop the LAT port driver.
Specify configuration characteristics for your service node and its
services.
Modify and display configuration characteristics.
Show system counters on the host computer.
To enable LATCP on a VMS system, enter one of the following commands:
$ MCR LATCP
or
$ RUN SYS$SYSTEM:LATCP
The application displays the LCP> prompt.
Examples
The following command shows the server characteristics for two
terminals:
LCP> SHOW SERVER
LCP Server Characteristics for LAT_08002B12D6FD
Ethernet address = 08-00-2B-12-D6-FD
Server is active Active users = 1
Link name = LAT$LINK
LCP Server Characteristics for LAT_08002B11D26E
Ethernet address = 08-00-2B-11-D2-6E
Server is active Active users = 4
Link name = LAT$LINK
The following command shows the port characteristics for a node
named TRACKS:

Table of Contents

Related product manuals