What to do if my DeDietrich Control Unit displays 'Configuration Error'?
If your DeDietrich Control Unit shows a 'Configuration Error', record the displayed code, then turn the boiler off and back on.
What should I do if my DeDietrich VM Diematic Evolution Control Unit shows 'Parameter Error'?
If the DeDietrich Control Unit displays a 'Parameter Error', the suggested solution is to write down the code that is displayed. After that, switch the boiler off, and then switch it on again.
General| Backlight | Yes |
|---|---|
| Operating Temperature | 0°C to +50°C |
| Storage Temperature | -20°C to +70°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Display | LCD |
| Languages | Multiple |
To Next Page