10 Maintaining the installation
10.1 Viewing the service notifications
When a service notification appears on the display, you can view the
details of the notification.
1. Select the Maintenance icon.
Information about maintenance is displayed (cannot be modified).
10.2
Resetting or re-establishing the parameters.
10.2.1 Auto-detecting options and accessories
Use this function after replacing a boiler PCB in order to detect all the
devices connected to the CAN bus.
To detect devices connected to the CAN bus:
1. Press the key.
2. Select Advanced Service Menu > Auto Detect.
3. Select Confirm to carry out the auto-detect.
10.2.2
Reverting to the commissioning settings
If the commissioning settings were saved in the boiler, you can revert to
the values specific to your installation.
To revert to the commissioning settings
1. Press the key.
2. Select Advanced Service Menu > Revert commissioning settings.
3. Select Confirm to revert to the commissioning settings.
10.2.3 Reverting to the factory settings
To revert to the factory settings for the boiler:
1. Press the key.
2. Select Advanced Service Menu > Reset to Factory Settings.
3. Select Confirm to revert to the factory settings.
10.3 Accessing information on the hardware and software versions
Information about the hardware and software versions of the different
appliance components is stored in the control panel.
To access:
1. Press the key.
2. Select Version Information.
3. Select the component for which you would like to see the version
information.
Component Description
EEC-01 Information about the PCB controlling the zones for heating and domestic hot water
MK3 - Diematic
Evolution
Information about the control panel
10 Maintaining the installation
7703592 - v02 - 14062018 45
To Next Page
Loading...
Need help?
General