48
Networking Guide
1 STEP™ Remote Viewing Setup Software
View your DVR footage remotely in minutes. 1 Step™ Remote Viewing Setup Software automatically connects your
Defender DVR Security System for viewing online from anywhere in the world in 1 easy step.
• Compatible with PC or Mac
• Use with virtually any router
• Simply install and run the application, enter your DVR's IP address and you are viewing your footage online
Simply click here http://www.defender-usa.com/1step/ to get started!
1 STEP
™
REMOTE VIEWING SOFTWARE INSTALLATION -
FOR MAC AND PC (For initial setup only)
STEP 1 - DVR/ROUTER SETUP
1. Connect DVR to Monitor/TV. Be sure to connect your DVR following the instructions in your DVR instruction manual.
2. Connect Ethernet cable directly into the Router and to the Ethernet port on the back of your DVR. Confirm that you
have a solid green light and an orange blinking light by the Ethernet cable connection.
3. Connect the mouse to the top USB port at the back of DVR.
Please ensure your router is connected to your DVR before powering on the DVR.
STEP 2 - NETWORK TAB
1. Access the MAIN MENU of your DVR using your mouse or remote and click on the NETWORK tab.
2. Check the IP type (mode) and set it to DHCP for initial setup.
3. Reboot the DVR after setting IP type to DHCP (unplug power adapter for 10 seconds and plug back in).
4. Access the MAIN MENU of your DVR and return to the NETWORK section.
Write down the following information:
• Your IP ADDRESS & GATEWAY number as they appear on the screen
• The CLIENT (MEDIA) port number
• The HTTP (WEB) port number
• The MOBILE port number
• Confirm that the UPNP is set to ENABLE
PLEASE NOTE: The IP ADDRESS & GATEWAY should be populated with numbers (not all zeros). EXAMPLE ONLY
(your numbers will be different): IP ADDRESS 192.168.001.101, GATEWAY 192.168.001.001. If you see all zeros in
the IP ADDRESS & GATEWAY fields, the connection is bad between the DVR and your router.
• Ensure the Ethernet cable being used is LESS than 30ft long.
• Disconnect the power to the DVR.
• Check the Ethernet cable connections to both the router and the DVR and that you have a solid green light and an
orange blinking light by the Ethernet cable connection.
• Reconnect the power to the DVR.
• Return to the NETWORK tab in your DVR menu to confirm that there is a connection between the DVR and the router.
PLEASE FOLLOW THE STEPS BELOW BEFORE INSTALLING AND USING THE 1 STEP
™
SOFTWARE.
To Next Page
Loading...