Deger MLD Control - Central Control Box (CCB); CCB: Pin Assignment

01/10/2021 ASSEMBLY INSTRUCTIONS MLD Control EC-6 with CCB III Page 12
3 Central Control Box (CCB)
3.1 CCB: Pin assignment
The clamping area on the cable fitting is designed for a cable cross-section of 3.5 mm to 7 mm.
Terminal
Function
Terminal
Function
20
Input (incline) DC 21 V
for snow sensor
A - B V
in
Input supply voltage
- DC 80 to 380 V
- AC 100 to 265 V
21
N/A
1 - 2
Output for EC-6 DC +/-21 V
EL axis
22
Input
from wind monitor
Wire Green
3 - 4
Output for EC-6 DC +/-21 V
AZ axis
23
Broken Wire Detection from Wind Monitor
GND
N/A
+ / -
Voltage supply DC 21 V, max. 1.4 A
for snow sensor and wind monitor
Red Wire of Wind Monitor
WH
N/A
2
1
2
0
2
2
2
3
Relay for
wind
monitor
Basic
(only for
CCB II)
open
open
open
open