Deger MLD Control - Symbols Used; Presentation of Information; Lists and Instructions; Notes on Safety

01/10/2021 ASSEMBLY INSTRUCTIONS MLD Control EC-6 with CCB III Page 7
- Safety goggles
- When working at heights in excess of 1 m, anti-fall measures and PPE to protect against falling.
- Any and all safety equipment and standards to be in compliance with Federal, provinces, and local codes
and OSHA standards
1.6 Symbols used
The following symbols appear on the DEGER system and are used in the present document:
No unauthorised access
Read and follow the operating manuals and safety information before start-up
1.7 Presentation of information
1.7.1 Lists and instructions
Lists
Lists have bullet points:
- List
- List
Instructions in a certain order
Instructions that must be followed in a certain order are numbered:
1. Step 1
2. Step 2
Instructions without a certain order
Instructions that do not have to be followed in a certain order are listed with bullet points:
 Instruction
 Instruction
Results
Results of an action are indicated by a double arrow:
>> Result
1.7.2 Notes on safety
The following safety information is used in this document:
DANGER!
Direct endangerment with high risk, failure to comply will lead to fatal or severe physical injuries.
WARNING!
Possible endangerment with medium risk, failure to comply can lead to fatal or severe physical
injuries.
CAUTION!
Low risk endangerment, failure to comply can lead to medium physical injuries.
ATTENTION!
Danger of material damage, when failing to comply with this note.