01/10/2021 ASSEMBLY INSTRUCTIONS MLD Control EC-6 with CCB III Page 32
11 Maintenance
No specific maintenance or repair work is required for the CCB or EC-6.
12 Cleaning
- Use soft towels for any necessary cleaning.
- Do not use corrosive or aggressive liquids.
- Follow the safety information in this operating manual.
13 Decommissioning
13.1 Disassembly
DANGER!
Electrical current can be fatal!
Contact with live components can be fatal due to electric shock.
Switch off the power supply before starting work and prevent the power from being switched back
on.
Only qualified personnel who have been trained in the tasks to be completed may perform
electrical work.
1. Move the DEGER system into the horizontal position using the CCB or a commercial battery pack
(DC 12 to 26 V). Connect the two wires of the elevation drive to the positive (+) and negative (-) terminal of
the battery pack. If the DEGER system moves into the inclined position, switch the wires for the elevation
drive at the (+) and (-) terminal of the battery pack.
2. Disconnect the DEGER system from the power supply.
13.2 Disposal
The parts can be recycled after disassembly, or they must be disposed of according to national and regional
stipulations. Only trained personnel may dispose of the parts.
To Next Page
Loading...