Deger MLD Control - Introduction; Fundamental Safety Notes; Exclusion of Liability; For Your Safety

01/10/2021 ASSEMBLY INSTRUCTIONS MLD Control EC-6 with CCB III Page 6
1.2 Introduction
These assembly instructions were created for the DEGER system. They are a component of the product and
must be saved for the entire lifespan of the DEGER system. The assembly instructions must be submitted
with the DEGER system should it be transferred to another party.
1.3 Fundamental safety notes
 Read these assembly instructions in their entirety before starting assembly work and keep them available
at all times during the assembly process.
 Only qualified personnel may perform assembly work.
 Keep all objects out of the DEGER system’s range of pivoting motion throughout its full range of motion.
 Take proper actions to protect the installed DEGER system in its full range of motion from unauthorised
access, such as enclosing it with a fence. Near the entry area to the DEGER system there must be a
warning sign stating that it is prohibited to remain within the range of pivoting motion.
 Lightning protection and grounding must be installed in all photovoltaic systems according to country-
specific guidelines as stipulated in DIN VDE 0185 and 0100.
 Do not operate the DEGER system if the wind monitor is not functioning. Always keep the module surface
in the SAFE position (table position) until the wind monitor has been tested for function.
1.4 Exclusion of liability
The General Terms and Conditions for Deliveries and Services (GTC) of DEGER are generally valid and
may be accessed on our website at www.DEGER.biz in the publisher information section. The contents of
these documents are continually checked and modified as needed. The assembly manual is also available
for downloading from the website www.DEGER.biz in the dealer section or can be ordered through the
normal sales channels.
Warranty and liability claims for any kind of damage are excluded if they can be traced back to any of the
following causes:
- Inappropriate or unintended use of the DEGER system and all parts of the MLD Control
- Operation of the DEGER system in an unintended environment
- Operation of the DEGER system while failing to comply with the locally valid statutory safety regulations
- Non-compliance with warnings and safety notes in all documents relevant to the product
- Operation of the DEGER system under unsound safety and protection conditions
- Unauthorized changes to the DEGER system's design, its component parts or their implementation in the
overall installation
- Unauthorized changes to the DEGER system
- Drilling holes in any housing, e.g. Central Control Box (CCB), Energy converter 6 (EC-6) and Evaluation
unit wind monitor (Use existing free holes for mounting the housings)
- Malfunction of the DEGER system caused by the effect of connected or adjacent devices beyond the
permissible limiting values
- Disaster situations and force majeure
- Installation of non-genuine DEGER replacement parts
- Unauthorized modifications to any parts
- Damages to any third party components (e.g. inverter or modules)
1.5 For your safety
1.5.1 Intended purpose of the DEGER system
The MLD control with EC-6 is intended only for the purpose of controlling DEGER systems.
DEGER systems can be used in the private and commercial sector. They are designed for outdoor
installation and for building integration.
1.5.2 Personal protective equipment
The customer must provide a sufficient amount of protective equipment for assembly and installation work.
Supervisors must check that this equipment is used.
The following protective equipment is required:
- Hard hat
- Safety shoes
- Safety gloves