2. Preparing for the installation
2.1 Tools
2.1.1 Tools required for mounting and installation
Tool Attachment Torque Used to Diagram
Safety equipment - -
Personal protection, according to local
standards and requirements.
-
OPTIONAL:
Conducting wrist
strap
- -
Prevent electrostatic discharge damage to
modules during mounting.
-
Torque screwdriver TX20 bit 0.5 N·m (4.4 lb-in)
Remove modules, or screw extra modules
into the rack. Not required if the required
modules are already mounted in the rack.
1 (red)
Torque screwdriver TX10 bit 0.5 N·m (4.4 lb-in)
Remove, or remount the cable strain relief
plates. The rack is delivered with the cable
strain relief plates already mounted.
-
Torque wrench*
10 mm hex socket for 6 mm
nuts (7/16 in hex socket for
1/4 in nuts)
5 N·m (44 lb-in) Tighten the nuts on the rack mounting bolts. 2 (green)
Torque screwdriver
PH2 bit or a 5 mm (0.2 in)
flat-bladed bit
0.15 N·m (1.3 lb-in)
Tighten the display unit fixing screw clamps. -
Torque screwdriver
3.5 mm (0.14 in) flat-bladed
bit
0.5 N·m (4.4 lb-in)
Connect the wiring to all the 2.5 mm²
terminals.
3 (blue)
Torque screwdriver
2.5 mm (0.1 in) flat-bladed
bit
0.25 N·m (2.2 lb-in)
Connect the wiring to the 1.5 mm² terminals. 4 (orange)
Torque screwdriver
3.5 mm (0.14 in) flat-bladed
bit
0.25 N·m (2.2 lb-in)
Remove or secure the current measurement
terminal block to the ACM3.1 module
faceplate. ACM3.1 is delivered with the
current measurement terminal block already
secured.
5 (brown)
Wire stripper, pliers
and cutters
- -
Prepare wiring.
Trim cable ties.
-
*Note: The size of the torque wrench attachment depends on the nut and bolt size of the mounting bolts. These parts are not
supplied by DEIF and the sizes mentioned are only a recommendation.
CAUTION
Do not use power tools during the installation. Too much torque will damage the equipment.
INSTALLATION INSTRUCTIONS 4189340909I UK Page 12 of 144
To Next Page
Loading...
