CAUTION
This panel cutout drawing is given as a guideline, and the dimensions will not be correct when printed. Use the dimensions
given to create your panel cutout template.
3.4.3 Mounting the display unit
The display unit is designed to be mounted in a panel, with its back in an enclosure.
For UL/cUL listing, the display unit must be:
• mounted on a flat surface of a type 1 enclosure.
• installed in accordance with the NEC (US) or the CEC (Canada).
MORE INFORMATION
See the Data sheet for more information about the electrical specifications.
The display unit is mounted using six fixing screw clamps (supplied with the display unit).
CAUTION
The back of the display unit is not protected against dust. Dust accumulation may damage the display unit or lead to
overheating. DEIF recommends mounting the display unit so that its back is in a cabinet with a filter on the air supply.
INSTALLATION INSTRUCTIONS 4189340909I UK Page 25 of 144
To Next Page
Loading...
