Deif PPM 300 - Hardware Configuration

Wire up the controller rack from left to right
DEIF recommends that you wire up the controller rack from left to right, because the wires are located on the left side of the 45º
terminal blocks.
4.2 Hardware configuration
4.2.1 Hardware configuration
The controller minimum hardware is described below. IOM3.1, IOM3.4, GAM3.1, GAM3.2 and EIM3.1 hardware modules can be
ordered and installed in the empty slots. Spare hardware modules may also be ordered for installation in the field.
Table 4.1
Minimum hardware configuration
Slot 1 Slot 2 Slot 3 Slot 4 Slot 5 Slot 6 Slot 7
PSM3.1 ACM3.1 Blind module Blind module Blind module Blind module PCM3.1
Power supply module
Alternating current
module
Processor and
communication module
1
2
3
4
5
6
7
8
F/G
PSM3.1
Multi‐line 300
+
‐
L1
L1
L2
L2
L3
L3
N
N
ACM3.1
L1
S1
S2
L2
S1
S2
L3
S1
S2
*
S1
S2
4
1
2
3
4
5
6
7
10
9
8
11
12
13
14
15
16
1
2
3
4
5
6
CAN-A
PCM3.1
CAN-B
CAN-A
CAN-B
1
2
3
4
5
L
H
H
L
Weight
Controller and display unit: 3118 g (6.9 lb)
Controller (minimum hardware): 2283 g (5.0 lb)
INSTALLATION INSTRUCTIONS 4189340909I UK Page 30 of 144