INFO
The diagram shows the relay terminals as seen from the back of the display unit.
INFO
It is not possible to configure the relay state. Therefore the relay is in a Normally open (NO) and De-energised state.
9.1.5 Ethernet connections
MORE INFORMATION
See Wiring the communication for more information regarding the specification of Ethernet cabling type and wiring
examples.
Connections
Table 9.3
Recommended default display unit connection to the controller
Connection Symbol Ethernet port position Recommended default connection
1 Right side, top port Controller
2 Right side, bottom port Ethernet for additional display units
INSTALLATION INSTRUCTIONS 4189340909I UK Page 132 of 144
To Next Page
Loading...
