Installation
step
Materials Purpose More information
Wiring
Wires
Wire the measurement points,
switchboard and/or third party equipment
to the controller/display unit terminals
See the Data sheet for the wiring
specifications for each terminal.
See the drawings from the system designer.
Ethernet cables
Connect the controller communication to:
• The display unit (2 m cable provided)
• Between controllers
• External systems
See the Data sheet for the Ethernet cable
specifications.
See the communication drawings from the system
designer.
Cable ties
Secure the rack wiring and Ethernet
cables
Secure the display unit wiring and
Ethernet cables
See Rack cable strain relief and Display
unit cable strain relief for more information.
2.3 Site
2.3.1 Site requirements
The equipment is designed to be installed and operated in a clean and dry environment as specified in the Data sheet. If the
equipment is installed in an area subject to constant high vibrations, sufficient precautions should be taken to isolate the equipment
from the vibrations. As a minimum requirement it is recommended that the installation environment complies with the electrical,
mechanical and environmental specifications of the equipment as described in the Data sheet.
CAUTION
If during or after installation of the equipment the electrical, mechanical or environmental specifications are exceeded, the
lifetime of the equipment will be reduced.
INSTALLATION INSTRUCTIONS 4189340909I UK Page 14 of 144
To Next Page
Loading...
