*Note: The default Ethernet connections.
The Ethernet ports on the controllers are not assigned to a particular service. The controllers detect the equipment connected to the
port. You therefore do not have to follow the list above. However, we recommend that you use the default connections to simplify
testing and troubleshooting.
MORE INFORMATION
See Wiring for the hardware modules, Processor and communication module PCM3.1, Ethernet connections for
more information.
INFO
The Ethernet lines must not be longer than 100 metres, point-to-point.
INSTALLATION INSTRUCTIONS 4189340909I UK Page 42 of 144
To Next Page
Loading...
