Deif PPM 300 - Page 86

12/24 V DC
0 V DC
COM
W
PNP input to W terminal
The connection of a PNP input, with a pull-down resistor, is shown below. The resistor, with resistance as recommended by the PNP
supplier, should be placed close to the controller module.
12/24 V DC
0 V DC
R
COM
W
NPN input to W terminal
The connection of an NPN input, with a pull-up resistor, is shown below. The resistor, with resistance as recommended by the NPN
supplier, should be placed close to the controller module.
INSTALLATION INSTRUCTIONS 4189340909I UK Page 86 of 144