3.4 Identification
The user can either log in at the Terminal with an ident card assigned to him, with an
assigned PIN or a combination of both. These settings as well as the determination of the
PIN (max. 8 digits) are carried out within the Commander Software.
After synchronizing the Commander Software with the data in the Terminal the determined
identification requests are available at the Terminal.
3.4.1 Identification by Card
For contactless identification by card the ident card has to be presented in front of the reader.
After a valid identification, which is confirmed by the illuminated green check mark on the
Terminal and 3 short beep tones, either the selection menu of taking and returning keyTags
appears or the Cabinet opens immediately in case only one keyTag had been assigned.
1 Select take or return procedure by
using the arrow keys.
2 Press green button on the keypad to
confirm your choice.
3 Press red “C”-button on the keypad to
leave this selection menu.
4 Entering a max. 8 digit number will be
acknowledged as PIN and will override
the currently registered user.
5 Presentation of an ident card will also
override the currently registered user.
6 Presentation of a keyTag will start a
return procedure for the presented
keyTag (if known in the terminal data).
7 After authorization as administrator
additionally the functional menu can be
selected by pressing the blue “F”-button.
10 ps_terminalc4_em v250909
proxSafe Terminal C4
John Smith
Take keyTags
Return keyTags
C:Cancel
F:Menu
To Next Page
Loading...