7.3.4 Settings (Auto Return/Beeper/Power Saving)
Moving the arrow keys and confirming your choice by pressing the green button or directly
entering the prefixed number leads you to the submenu ”4 Settings”.
Auto Return
In this submenu you have the possibility to determine the way of returning keyTags at the
Terminal itself. In case the device is configured in the way “Auto Return: On”, the keyTag
may be returned with or without previous identification. For a return with personal
identification either the user card has to be presented in front of the reader or the PIN has
to be entered. For a return without identification it is sufficient to present only the keyTag in
front of the reader (see also 3.2 “Presenting a keyTag”). If the device is configured in the
way “Auto Return: Off”, the keyTag can only be returned after previous identification by
user card or PIN.
1 The display shows the current
configuration.
2 Select “Auto Return” by using the
arrow keys.
3 Press the green button for switching
from “ON” to “Off” and back again.
4 Press the red button in order to store
the selected changes within the “Auto
Return” configuration.
The standard configuration (i.e. factory setting) of “Auto Return” is “On”.
Beeper
Furthermore the internal beeper of the Terminal can be activated or deactivated in this
submenu. The deactivation stops any sounds that can be heard while pressing keys on the
keypad.
1 The display shows the current settings.
2 Select “Beeper” by using the arrow
keys.
3 Press the green button in order to
switch the beeper from “ON” to “Off”
and back again.
4 Press the red button in order to leave
the submenu “4 Settings” without
storing any changes.
The standard configuration (i.e. factory setting) of “Beeper” is “On”.
28 ps_terminalc4_em v250909
proxSafe Terminal C4
Auto Return : On
Beeper : On
Power Saving: PwrDn
:Select :Change
Auto Return : On
Beeper : On
Power Saving: PwrDn
:Select :Change
To Next Page
Loading...