9. Restart
After an update of the firmware or after discrepancies with the hardware/software it is
necessary to restart the system for communicating any changes within the firmware or to
get back to the old status of the Terminal. The restart can only be carried out after
successful identification as administrator (with card or PIN). In order to do so go to the
functional menu using the “F”-button, select the submenu “Restart” (with no prefixed
number) by moving the arrow keys and then confirm by pressing the green button.
At the beginning of the restart the contrast of the Terminal display changes to very low contrast.
Afterwards all devices operated by the Terminal are checked one after another showing the
currently to be checked device on the display. Further information as the number of
proxCylinders or the type of reader follows ending with the symbol of the device status.
9.1 Reset to Factory Settings
In order to reset to factory settings, a restart has to be carried out first (see 9. “Restart”)
and then the number “9” has to be pressed after the backlight of the display has been
turned off. After this reset all data base entries will be deleted. The Terminal starts
a new addressing routine including the re-identification of the connected proxSafe devices.
This procedure offers a reorganization of the keyTags and the users at the Terminal as well
as integrating newly added proxSafe devices. All keyTag-/user assignments carried out at
the Terminal will afterwards be lost and have to be set up at the Terminal again.
36 ps_terminalc4_em v250909
proxSafe Terminal C4
To Next Page
Loading...