Deister electronic proxSafe C4 - 7.3.2 LCD Contrast; 7.3.3 Set Clock

7.3.2 LCD Contrast
Depending on the lighting conditions in the actual environment the contrast of the LCD
display may has to be adjusted. Moving the arrow keys and confirming your choice by
pressing the green button or directly entering the prefixed number leads you to the
submenu “2 LCD Contrast”.
1 Select the desired contrast on the
display between 1 and 9 by moving
the arrow keys (1 strong contrast; 9
weak contrast).
2 Confirm your choice by pressing the
green button (“apply”).
3 Press the red button in order to cancel
the contrast change routine.
7.3.3 Set Clock
The time and date on the Terminal display will automatically be adjusted, while the
Terminal is synchronized with the Commander Software. If in some cases a manual
adjustment of time and date becomes necessary, they can directly be adjusted at the
Terminal. In order to do so, please proceed as follows:
Moving the arrow keys and confirming your choice by pressing the green button or directly
entering the prefixed number leads you to the submenu “3 Set Clock”.
The date is defined in the following formate DD.MM.JJ (=day, month, year) and
shows for instance July 24th, 2006 in the form 24.07.06. The time is defined in the
formate HH:MM:SS (= hour, minute, second).
1 The current date and time are shown
on the display. The empty bars above
serve as placeholders for each digit of
date and time.
2 Changes can be made by entering
numbers from 0 to 9 starting with the
numbers of the day and ending with
the numbers of the time.
3 After entering the last number of the
seconds the changes are stored
immediately.
4 Press the red button on the keypad in
order to cancel the set clock routine
without storing any changes.
v250909 ps_terminalc4_em 27
proxSafe Terminal C4
Use  to change
LCD Contrast
01
C:Cancel  :Apply
Set Clock
 --.--.-- --:--:--
Mo 24.07.06 09:15:10
C:Cancel 0-9:Edit