7.5.2 Release wrong keyTags
1 Select “Wrong keyTags” by using the
arrow keys and confirming with the
green button or by entering the
prefixed number (here:2).
2 Press the red “C”-button in order to
cancel the release keyTag-procedure.
After confirming with the green “Entry”-button the opening procedure of the Cabinet starts
and an according message is given on the display.
When the opening procedure (see also 7.5.1 “Release all keyTags”) is finished the first
occupied slot with the first falsely returned keyTag in the Cabinet is illuminated. The assigned
proxCylinder releases the inserted keyTag and the keyTag can be taken out. Afterwards the
next proxCylinder with a falsely returned keyTag is being activated, illuminated and unlocked
for take out of wrong keyTags. Remove this second wrong keyTag as well and proceed in
the same way, until all falsely returned keyTags have been removed from the Cabinet. In
case of devices that require manual door opening the procedure is alike after the
door/drawer has been released to be opened.
8. Demo Mode
The Demo Mode has been specially arranged for performing reasons at fairs or other
presentations. If it is started within the functional menu, a course of events such as the
opening of the roller shutter or the illuminating and releasing of the proxCylinders is
initiated after a certain defined pattern. Nevertheless this mode should not be used in
normal working routine.
After successful identification as administrator you reach the functional menu by pressing
the blue “F”-button.
In order to call up the Demo Mode select “6 Switch Demo on” by either using the arrow keys
on the keypad and confirming with the green button or directly entering the prefixed number.
v250909 ps_terminalc4_em 35
proxSafe Terminal C4
1 All keyTags
2 Wrong keyTags
To Next Page
Loading...