4. Take out keyTags
4.1 Terminal Identification
Taking keyTags is only possible with prior identification. This identification at the Terminal can
either be carried out by presenting the ident card in front of the reader, by entering the PIN or
by a combination of both and gives the user access to the Terminal. In case only one keyTag
has been assigned to the user, the proxSafe Cabinet opens automatically and releases the
particular keyTag for take out. If several keyTags are assigned to one ident card or the access
to the Terminal was granted to an administrator, the following selection menu is shown on the
Terminal display. In case of non-successful or non-valid identification the message “Access
Denied” is given on the display.
1 Select “Take keyTags” by using the
arrow keys on the keypad and confirm
by pressing the green button.
2 All keyTags, that are assigned and
therefore may be taken, are listed on
the display.
3 Select the wanted keyTag by pressing
the arrow keys on the keypad or
alternatively enter the number directly
without the leading zeros (e.g “3” for
“Depot”). The selected number of the
keyTag is shown on the display.
4 Press green button on the keypad and
the Cabinet will open.
5 Press red button on the keypad to
cancel the take out-routine and to return
to the selection above (see #1).
After confirming with the green “Entry”-button the opening procedure of the Cabinet starts
and an according message is given on the display. When the opening procedure is
finished the slot inside the Cabinet is illuminated by a red light and the according
proxCylinder releases the inserted keyTag.
v250909 ps_terminalc4_em 13
proxSafe Terminal C4
John Smith
Take keyTags
Return keyTags
C:Cancel
0001 Main Entrance
0002 Visitor's Lounge
0003 Depot
C:Cancel :Release
To Next Page
Loading...