7.4.3 Readdress Cabinets
By adding new devices from the proxSafe family, such as maxx Cabinets or flexx housings
to one Terminal it often becomes necessary to readdress the new devices because the bus
addresses of the newly added devices may possibly be identical to those of the devices
already set up at the Terminal. This address management can directly be carried out at the
Terminal as well.
Changes of the device bus addresses should only be carried out by professionals (i.e.
installers).
Please refer to chapters 5.3 “Addressing of Cabinets” and 5.4 “Teach-in of keyTags” in
the “Wiring and Installation Instructions” for the “proxSafe maxx” or the according
chapters in the “Wiring and Installation Instructions” for the “proxSafe flexx”.
7.5 Release keyTags
For different reasons it can be necessary to release all keyTags at once from the
proxCylinders or to take out falsely returned keyTags from the housing to insert them
correctly again. Falsely returned keyTags are usually those, which have not been returned
to their assigned proxCylinders even after illumination of the right proxCylinder and an
acoustic warning signal. They may also be wrong because their assigned proxCylinder has
become invalid after a change of master data within the Commander Software.
After successful identification as administrator you reach the functional menu by pressing the
blue “F”-button.
Then select “5 Release keyTags” by either using the arrow keys on the keypad and confirming
with the green button or directly entering the prefixed number.
7.5.1 Release all keyTags
1 Select “All keyTags” by using the arrow
keys and confirming with the green
button or by entering the prefixed
number (here:1).
2 Press the red “C”-button in order to
cancel the release keyTag-procedure.
After confirming with the green “Entry”-button the opening procedure of the Cabinet starts
and an according message is given on the display.
In case of a proxSafe maxx Cabinet the roller shutter will automatically roll up and the first
occupied slot in the Cabinet is illuminated. The according proxCylinder releases the
inserted keyTag and the keyTag can be taken out. Afterwards the next proxCylinder is
activated, illuminated and unlocked for take out of keyTags. Remove this second keyTag
as well and proceed in the same way until all keyTags have been removed from the
Cabinet. In case of devices that require manual door opening the procedure is alike after
the door/drawer has been released and can be opened.
34 ps_terminalc4_em v250909
proxSafe Terminal C4
1All keyTags
2 Wrong keyTags
To Next Page
Loading...