Deister electronic proxSafe C4 - 7.3.5 Bus Address

7.3.5 Bus Address
Adding new Terminals often requires a change of the Terminal bus address of the RS485
interface because the addresses of the newly added Terminals might be identical.
Organizing the bus addresses can also be carried out directly at the Terminal. Select the
new address by moving the arrow keys and confirm with “Apply” (Note: bus address 24 is
reserved for the boot loader).
Attention:
Changes of the Terminal bus addresses should only be carried out by
professionals (i.e. installers). Please refer to the “Wiring and Installation
Instructions” for the proxSafe maxx or the proxSafe flexx.
30 ps_terminalc4_em v250909
proxSafe Terminal C4