Dell EMC ES40 User Manual

Figure 23 Installing the front bezel
CL4562
Closing the console
About this task
If you opened the console for access to the enclosure with the part you added or replaced, close
the console using the procedure that follows.
Procedure
1. Grasp the free side of the console, and swing the console to the right to close it
2. Gently push on the console until it is closed.
Chassis Replacement
This section describes how to replace a shelf chassis.
Shut down and disconnect the system
Procedure
1. Stop the system using the system poweroff command to allow the proper shut down of
the file system and other system components.
Note: The system poweroff command completes when the front panel blue LED
turns off.
For help connecting to a system using a laptop computer and terminal emulator, see the
document
FE Toolkit Inventory and Common Procedures for FRU Tasks at https://
support.emc.com.
2. Label each of the cables as to their connection location. Taking a photograph for reference
is also helpful for re-connecting the cables.
3. Disengage the wire clips, then disconnect both AC power cords from the rear of the system.
Removing and replacing FRUs
36 Dell EMC ES40 Expansion Shelf Guide Field Replacement Unit Guide

Dell EMC ES40 Specifications

General

Brand	Dell EMC
Model	ES40
Category	Indoor Furnishing
Language	English