Once the trust command has been issued on a disk group, further troubleshooting steps may be limited towards disaster recovery. If you
are unsure of the correct action to take, contact technical support for further assistance.
Events sent as indications to SMI-S clients
If the storage system’s SMI-S interface is enabled, the system will send events as indications to SMI-S clients so that SMI-S clients can
monitor system performance. For information about enabling the SMI-S interface, see the chapter about conguring the system in your
product’s Storage Management Guide.
The event categories below pertain to FRU assemblies and certain FRU components.
FRU/Event category Corresponding SMI-S class Operation status values that would trigger alert conditions
Controller
DHS_Controller Down, Not Installed, OK
Hard Disk Drive
DHS_DiskDrive Unknown, Missing, Error, Degraded, OK
Fan
DHS_PSUFan Error, Stopped, OK
Power Supply
DHS_PSU Unknown, Error, Other, Stressed, Degraded, OK
Temperature Sensor
DHS_OverallTempSensor Unknown, Error, Other, Non-Recoverable Error,
Degraded, OK
Battery/SuperCap
DHS_SuperCap Unknown, Error, OK
FC Port
DHS_FCPort Stopped, OK
SAS Port
DHS_SASTargetPort Stopped, OK
iSCSI Port
DHS_ISCSIEthernetPort Stopped, OK
140 Events and event messages
To Next Page
Loading...
