Dell EMC ME4 Series - Installing a PCM

To Next Page

To Previous Page

Figure 63. Removing a PCM (1 of 2)

8 Grip the handle and withdraw the PCM, taking care to support the base of the module with both hands as you remove it from the

enclosure as shown in Figure 64. Removing a PCM (2 of 2).

Figure 64. Removing a PCM (2 of 2)

NOTE

: The remove PCM illustrations show a chassis congured as a 4-port FC/iSCSI controller enclosure. The

procedure applies to all 2U controller enclosures and expansion enclosures.

9 If replacing two PCMs, repeat steps 5 through 8, being mindful of the illustrations Note.

Installing a PCM

Refer to Figure 63. Removing a PCM (1 of 2) and Figure 64. Removing a PCM (2 of 2) when performing this procedure, but ignore the

directional arrows—since you will insert the module into the slot rather than extract.

NOTE

: Handle the PCM carefully, and avoid damaging the connector pins. Do not install the PCM if any pins appear to be bent.

1 Check for damage, especially to all module connectors.

2 With the PCM handle in the open position, slide the module into the enclosure, taking care to support the base and weight of the

module with both hands.

Module removal and replacement

Other manuals for Dell EMC ME4 Series