Steps
1 Insert the edge connector of the M.2 SATA card into the connector on the board, and push the card in.
2 Using the Phillips #1 screwdriver, secure the card in place.
Figure 58. Installing the M.2 SATA card on the SATA x16 riser
Figure 59. Installing the M.2 SATA card on the SATA x8 mezzanine card
Next steps
1 If removed, install the expansion card riser assembly.
2 Install the M.2 x16 riser or install the M.2 SATA x8 mezzanine card.
NOTE
: The procedure to install the M.2 SATA x8 mezzanine card is similar to installing a mezzanine card.
3 Follow the procedure listed in After working inside your enclosure.
110
Installing and removing enclosure components
To Next Page
Loading...
