Figure 28. Removing the linking board and SATA cable
Next step
1 Install the linking board and PCIe cables.
Installing the linking board and PCIe cables
Prerequisite
NOTE
: Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to prevent
the cable from being pinched or crimped.
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Insert the PCIe_A connector into the connector on the system board, press the connector until it locks into place.
2 Insert and press the PCIe_B connector into the connector on the system board, press the connector until it locks into place.
3 If disconnected, reconnect the SATA cable to the x16 M.2 riser.
4 Using the Phillips #1 screwdriver, tighten the captive screws on the linking board to secure the board to the sled.
Installing and removing enclosure components
81
To Next Page
Loading...
