Dell EMC PowerEdge C6420 - Installing the PERC Battery

Figure 19. Removing the PERC battery
Next step
1 Install the PERC battery.
Installing the PERC battery
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in After working inside your enclosure.
3 Install the sled from the enclosure.
4 If applicable, connect the battery cable from the PERC card.
Steps
1 Align and insert the non cable end of the PERC battery into the battery slot on the air shroud.
2 Press the battery until it locks into place.
70
Installing and removing enclosure components