Figure 79. Removing the ller bracket
NOTE
: Store the ller bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain FCC
certication of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airow
inside the system.
3 Holding the card on the edges, align the card with the expansion card connector on the system board.
4 Press the expansion card rmly into the expansion card connector on the system board until the card is fully seated.
5 Close the expansion card retention latch by pushing the latch down until the latch snaps into place.
126
Installing and removing system components
To Next Page
Loading...
