Figure 45. Removing a drive blank
Next step
1 Installing a drive blank
Installing a drive blank
The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical.
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, Removing the front bezel
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 46. Installing a drive blank
Next step
If removed, Installing the front bezel
92
Installing and removing system components
To Next Page
Loading...
