Figure 34. Removing cooling fan
Next steps
1 Installing cooling fan.
2 Installing the internal PERC riser
3 Installing the air shroud
4 Follow the procedure listed in After working inside your system.
Installing cooling fan
The procedure for installing standard and high performance fans are identical.
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Removing the air shroud
4 Removing the internal PERC riser
5 Remove the power cable.
6 Move the cables out of the way to access the cooling fan cable connector on the system board.
Steps
1 Holding the release tab blue touch point, place the cooling fan into the cooling fan cage.
2 Route the cooling fan cable and connect it to the connector on the system board.
82
Installing and removing system components
To Next Page
Loading...
