Dell EMC PowerEdge R540 - Installing the Front Bezel; System Cover; Removing the System Cover

Installing the front bezel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Locate and remove the bezel key.
NOTE: The bezel key is part of the LCD bezel package.
2 Align and insert the right end of the bezel onto the system.
3 Press the bezel until the button clicks in place and t the left end of the bezel onto the system.
4 Lock the bezel by using the key.
Figure 24. Installing the front bezel with the LCD panel
System cover
NOTE
: The system cover of 12 x 3.5-inch + 2 x 3.5-inch (rear) system is dierent from other systems. The cover has one
additional mylar and foam layer on the front side of the system cover.
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Turn o the system, including any attached peripherals.
3 Disconnect the system from the electrical outlet and disconnect the peripherals.
70
Installing and removing system components