Dell EMC PowerEdge R540 - Installing the LOM Riser Card

Figure 93. Removing LOM riser card
Next step
Installing the LOM riser card
Installing the LOM riser card
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the connectors on the LOM riser card with the slot on the system.
2 Press the LOM riser card until the card is rmly seated on the system board connector and the two blue plastic snap hold the LOM
riser card in place.
3 Using a Phillips #2 screwdriver, replace the screws to secure the LOM riser card to the system board.
138
Installing and removing system components