Figure 108. Installing the rear drive cage
Next steps
1 Reconnect all the disconnected cables to the rear drive backplane.
2 Install all the drives.
3 Follow the procedure listed in After working inside your system.
System battery
Replacing the system battery
Prerequisites
WARNING
: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, disconnect the power or data cables from expansion card(s).
4 If installed, remove the low prole or full height X1 expansion card risers.
Steps
1 Locate the battery socket. For more information, see the System board jumpers and connectors.
Installing and removing system components
151
To Next Page
Loading...
