Dell EMC PowerEdge R540 - VGA Ports; Serial Connector; Internal Dual SD Module; Video Specifications

VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The Dell EMC PowerEdge R540 system supports
two 15-pin VGA ports.
Serial connector
The serial connector connects a serial device to the system. The Dell EMC PowerEdge R540 system supports one serial connector on the
back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
Internal Dual SD Module
The Dell EMC PowerEdge R540 system supports two optional ash memory card slots with an internal dual MicroSD module.
NOTE: One card slot is dedicated for redundancy.
Video specications
The PowerEdge Dell EMC PowerEdge R540 system supports Matrox G200eR2 graphics card with 16 MB capacity.
Table 24. Supported video resolution options
Resolution Refresh rate (Hz) Color depth (bits)
640x480 60,70 8, 16, 32
800x600 60,75, 85 8, 16, 32
1024x768 60,75, 85 8, 16, 32
1152x864 60,75, 85 8, 16, 32
1280x1024 60,75 8, 16, 32
1440x900 60 8, 16, 32
Environmental specications
NOTE
: For additional information about environmental certications, please refer to the Product Environmental Datasheet
located with the Manuals & Documents on Dell.com/poweredgemanuals
Table 25. Temperature specications
Temperature Specications
Storage –40°C to 65°C (–40°F to 149°F)
Continuous operation (for altitude less than 950 m or 3117
ft)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the equipment.
Fresh air For information about fresh air, see the Expanded Operating Temperature
section.
Technical specications 37