Dell EMC PowerEdge R540 - Removing the PERC Card from the Internal PERC Riser

Figure 40. Installing internal PERC riser
5 Connect the cables to the backplane and then route the cables to the cable guiding latch to close the latch.
Next steps
1 Installing the air shroud
2 Follow the procedure listed in After working inside your system.
Removing the PERC card from the internal PERC riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Removing the air shroud
4 Removing the internal PERC riser
Steps
1 Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
2 Pull the PERC card out of the connector on the internal PERC riser.
Installing and removing system components
87